Dynex DX-TVM111 Manuel d'assemblage - Page 5
Parcourez en ligne ou téléchargez le pdf Manuel d'assemblage pour {nom_de_la_catégorie} Dynex DX-TVM111. Dynex DX-TVM111 13 pages. Quick setup guide (french)
Également pour Dynex DX-TVM111 : Manuel d'installation rapide (2 pages), (anglais) Quick Configuration Guide (2 pages), (français) Guide D'installation Rapide (2 pages)
Imprimer la page
Installation instructions
STEP 2 - Option 1: Installing on a wood stud* wall
Note: Any drywall covering the wall must not exceed 5/8" (16 mm).
1 Locate the stud. Verify the center of the stud with an edge-to-edge stud finder.
2 Align the wall plate template (J) at the height you determined in the previous step and make sure that it is
level. Tape the wall plate template in position, then use a pencil to mark the lag bolt hole locations (2).
Remove the wall plate template.
3 Drill pilot holes to a depth of 2.5 in. (63.5 mm) using a 1/8" (3 mm) wood drill bit.
4 Align the wall plate (B) with the pilot holes, insert the lag bolts (G) through the holes in the wall plate, then
tighten the lag bolts only until they are firm against the arm assembly.
CAUTION:
DO NOT over-tighten the lag bolts (G).
* Minimum wood stud size: common 2 x 4 in. (51 x 102 mm)
nominal 11/2 x 31/2 in. (38 x 89 mm).
You'll need
G (2)
Level
Wall plate (B)
Avoid potential injuries or property damage!
Template • Gabarit • Plantilla
Note
Remarque : Pour une construction à ossature de bois,
localiser d'abord les montants en bois, à l'aide d'un
détecteur de montants.
Nota: para la instalación en construcciones de armazón de
madera, primero debe localizar las vigas de madera con un
localizador de vigas.
Edge-to edge
http://san.us/284
stud finder
Template (J)
J
DX-TVM111
Top
Haut
Parte superior
Tools Needed
Outils nécessaires
Herramientas requeridas
Pencil
Need more information about your mount? Scan
this QR code or visit www.dynexproducts.com.
<FR>Need more information about your mount?
Scan this QR code or visit www.dynexproducts.com.
<SP>Need more information about your mount?
Scan this QR code or visit www.dynexproducts.com.
V1 13-0138
Tape
DX-TVM111
2.5 in.
(63.5 mm)
1/8" wood
drill bit
Drill
5
7/16" socket
wrench