Dynex DX-TVM111 조립 설명서 - 페이지 5

{카테고리_이름} Dynex DX-TVM111에 대한 조립 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dynex DX-TVM111 13 페이지. Quick setup guide (french)
Dynex DX-TVM111에 대해서도 마찬가지입니다: 빠른 설정 매뉴얼 (2 페이지), (영어) 빠른 구성 가이드 (2 페이지), (프랑스어) 빠른 설치 가이드 (2 페이지)

페이지 인쇄

Installation instructions

STEP 2 - Option 1: Installing on a wood stud* wall

Note: Any drywall covering the wall must not exceed 5/8" (16 mm).

1 Locate the stud. Verify the center of the stud with an edge-to-edge stud finder.

2 Align the wall plate template (J) at the height you determined in the previous step and make sure that it is

level. Tape the wall plate template in position, then use a pencil to mark the lag bolt hole locations (2).

Remove the wall plate template.

3 Drill pilot holes to a depth of 2.5 in. (63.5 mm) using a 1/8" (3 mm) wood drill bit.

4 Align the wall plate (B) with the pilot holes, insert the lag bolts (G) through the holes in the wall plate, then

tighten the lag bolts only until they are firm against the arm assembly.

CAUTION:

DO NOT over-tighten the lag bolts (G).

* Minimum wood stud size: common 2 x 4 in. (51 x 102 mm)

nominal 11/2 x 31/2 in. (38 x 89 mm).

You'll need

G (2)

Level

Wall plate (B)

Avoid potential injuries or property damage!

Template • Gabarit • Plantilla

Note

Remarque : Pour une construction à ossature de bois,

localiser d'abord les montants en bois, à l'aide d'un

détecteur de montants.

Nota: para la instalación en construcciones de armazón de

madera, primero debe localizar las vigas de madera con un

localizador de vigas.

Edge-to edge

http://san.us/284

stud finder

Template (J)

DX-TVM111

Top

Haut

Parte superior

Tools Needed

Outils nécessaires

Herramientas requeridas

Pencil

Need more information about your mount? Scan

this QR code or visit www.dynexproducts.com.

<FR>Need more information about your mount?

Scan this QR code or visit www.dynexproducts.com.

<SP>Need more information about your mount?

Scan this QR code or visit www.dynexproducts.com.

V1 13-0138

Tape

DX-TVM111

2.5 in.

(63.5 mm)

1/8" wood

drill bit

Drill

7/16" socket

wrench