Coralife 300G Manuel d'instructions - Page 2
Parcourez en ligne ou téléchargez le pdf Manuel d'instructions pour {nom_de_la_catégorie} Coralife 300G. Coralife 300G 7 pages. Cone skimmers
Imprimer la page
IMPORTANT SAFETY
INSTRUCTIONS
READ AND FOLLOW ALL SAFETY
INSTRUCTIONS
CAUTION
To guard against injury, the following basic safety precautions should be
observed when operating the unit.
1. Never connect the Coralife Cone Skimmer to any power source while
hands are wet.
2. Always unplug the unit from outlet or power source before installing,
replacing parts or doing product maintenance.
3. Never allow pump to run dry. Always keep pump submerged during
operation. Failure to keep pump submerged while in use may damage
the unit and/or cause unit failure.
4. Always leave a drip-loop in the pump cord to prevent water from running
down the length of the cord and reaching the power source or outlet.
5. For added safety, the pump should be plugged into a grounded
three-prong receptacle controlled by a GFI (Ground Fault Interrupter)
circuit breaker.
6. Make sure that the Cone Skimmer is securely installed before operating.
PRE-INSTALLATION SETUP
NOTE: Prepare at least 5 gallons of "make-up water" to replace water
used by the Cone Skimmer.
SUMP HOOK-UP PLACEMENT
1. Verify that there is adequate space for the Cone Skimmer in the sump.
2. Confirm that sump is large enough to hold additional water from skimmer
and aquarium drainage in the event power is lost.
3. Allow a minimum 1" clearance between the underside of the stand
and the top of the skimmer. Make sure there is enough head space to
remove the collection cup from skimmer.
POWER
SUPPLY
CORD
AQUARIUM
DRIP
LOOP
PARTS DIAGRAM
TANK
1.0
Collection Cup Lid
Collection Cup
Collection Cup
Drain Plug
Collection Cup
Drain Tubing
(0.25" I.D.)
Water-Level
Adjustment Dial
Air-inlet Silencer
with Tubing
(0.25" I.D. clear)
Main Chamber
Bubble Diffusion
Plate
Water Pump
(650 - 750 gph)
Venturi Air Inlet
Skimmer Intake
Output Tubing
Round Diffuser
Sponge
2