Coralife 300G 사용 설명서 - 페이지 2

{카테고리_이름} Coralife 300G에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Coralife 300G 7 페이지. Cone skimmers

페이지 인쇄

IMPORTANT SAFETY

INSTRUCTIONS

READ AND FOLLOW ALL SAFETY

INSTRUCTIONS

CAUTION

To guard against injury, the following basic safety precautions should be

observed when operating the unit.

1. Never connect the Coralife Cone Skimmer to any power source while

hands are wet.

2. Always unplug the unit from outlet or power source before installing,

replacing parts or doing product maintenance.

3. Never allow pump to run dry. Always keep pump submerged during

operation. Failure to keep pump submerged while in use may damage

the unit and/or cause unit failure.

4. Always leave a drip-loop in the pump cord to prevent water from running

down the length of the cord and reaching the power source or outlet.

5. For added safety, the pump should be plugged into a grounded

three-prong receptacle controlled by a GFI (Ground Fault Interrupter)

circuit breaker.

6. Make sure that the Cone Skimmer is securely installed before operating.

PRE-INSTALLATION SETUP

NOTE: Prepare at least 5 gallons of "make-up water" to replace water

used by the Cone Skimmer.

SUMP HOOK-UP PLACEMENT

1. Verify that there is adequate space for the Cone Skimmer in the sump.

2. Confirm that sump is large enough to hold additional water from skimmer

and aquarium drainage in the event power is lost.

3. Allow a minimum 1" clearance between the underside of the stand

and the top of the skimmer. Make sure there is enough head space to

remove the collection cup from skimmer.

POWER

SUPPLY

CORD

AQUARIUM

DRIP

LOOP

PARTS DIAGRAM

TANK

1.0

Collection Cup Lid

Collection Cup

Drain Plug

Collection Cup

Drain Tubing

(0.25" I.D.)

Water-Level

Adjustment Dial

Air-inlet Silencer

with Tubing

(0.25" I.D. clear)

Main Chamber

Bubble Diffusion

Plate

Water Pump

(650 - 750 gph)

Venturi Air Inlet

Skimmer Intake

Output Tubing

Round Diffuser

Sponge