Dynisco 1490 Manuel d'utilisation - Page 12

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Dynisco 1490. Dynisco 1490 20 pages. Din indicator
Également pour Dynisco 1490 : Manuel du produit (2 pages)

Imprimer la page
Dynisco 1490 Manuel d'utilisation
From lab to production,
providing a window into the process
When the calibration procedure begins ---- appears on the screen. Once the calibration is complete
donE appears on the screen.
If there are faults detected with the calibration the error message ErCAL will
appear.
ErCAL appears during the low calibration step if the offset is greater than -10mV, for example -11mV.
This could signify a faulty sensor.
ErCAL appears during the high calibration step if the count value is greater than +50mV. Again this
could signify a faulty sensor.
Note: Performing a calibration with less than a 10mV difference between the high and low
calibration values will compromise the accuracy of the instrument.

6. Special Mode

Note: Configuration must be completed before adjusting Special parameters.
This mode enables special features with the correct code entered; enter a value of 0 as default
otherwise please refer to your supplier for information on what special features are available and
which numbers invoke these.
7. Messages & Error Indications
These messages indicate that the instrument may require attention, or there is a problem with the
signal input connection.
Caution:
Do not continue with the process until the issue is resolved.
The message legend is shown for 1 second, followed by its value.
P/N: n/a
Rev: n/a
www.dynisco.com
ECO: n/a
-12-