Galvin Engineering CliniMix 100.91.10.20 Manuels d'installation - Page 2

Parcourez en ligne ou téléchargez le pdf Manuels d'installation pour {nom_de_la_catégorie} Galvin Engineering CliniMix 100.91.10.20. Galvin Engineering CliniMix 100.91.10.20 4 pages. Bs lead safe thermostatic cartridge assembly for cmv2 low flow

Imprimer la page

Product Installation Guidelines

INSTALLATION

INSTALLATION COMPLIANCE: Galvin Engineering products must be installed in accordance with these

installation instructions and in accordance with AS/NZS 3500, the PCA and your local regulatory requirements.

Water and/or electrical supply conditions must also comply to the applicable national and/or state standards.

Failing to comply with these provisions shall void the product warranty and may affect the performance of the

product.

1. Close the mains and deinstall Spout

Close off both (hot and cold) water

mains or power main. Ensure water is

not flowing when hand waving in front

of the sensor.

Loosen grab screw to unlock the

spout. Pull and gently remove the

spout.

Removing the disinfection key cover

plug might help with detaching the

faceplate in next steps.

3. Ensure water is closed

Turn the isolating valve to 'CLOSE'

position.

2. Remove the faceplate

Loosen the grub screw shown on above

picture.

Unscrew the locking nut and remove.

Remove the flange.

Carefully remove the faceplate.

Do not change the position of the backnut if

not necessary.

Disconnect sensors' and solenoids' cables

connections.

Plastic ring

4. Remove locking ring

Break/remove the plastic lock in the centre

of the thermostatic mixing valve.

Version 1, 14 September 2022, Page 2 of 4