AGS Merlin GDP4 Manuel de l'utilisateur - Page 8

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} AGS Merlin GDP4. AGS Merlin GDP4 12 pages. Gas safety products, gas detection panel

Imprimer la page
Merlin GDP4
5

Maintenance

To keep your panel in good working order, you must follow these steps:
 DO carefully remove any accumulated dust from the outer enclosure once a month.
NEVER use detergents or solvents to clean your device – this may permenantly or temporarily
damage the panel
NEVER spray air fresheners, hair spray, paint or other aerosols near the device.
NEVER paint the device. Paint will seal vents and interfere with the device.
6

GDP4 Wiring Spec

1.
POWER: Mains Input 110-120VAC.
2.
GAS VALVE: Gas Solenoid Valve Power Output, 110-120VAC.
3.
GAS DETECTOR ZONE 1: 24VDC power supply (purchased separately).
4.
GAS DETECTOR ZONE 2: 24VDC power supply (purchased separately).
5.
GAS DETECTOR ZONE 3: 24VDC power supply (purchased separately).
6.
GAS DETECTOR ZONE 4: 24VDC power supply (purchased separately).
7.
EM REMOTE: Remote emergency stop buttons (purchased separately). VOLT FREE
INPUT
8.
HEAT SENSOR: Fusible Links (purchased separately). VOLT FREE INPUT
9.
FIRE PANEL (Supplied by others). VOLT FREE INPUT
10.
BMS OUT: output contacts. Normally Open, Common and Normally Closed.
11.
SOUNDER/STROBE: Alarm, 24VDC power supply (purchased separately).
12.
AUTO RESET & BMS SELECTION SWITCH
13.
ZONE ENABLE/DISABLE SWITCH
Rev: 06 05-19
User Guide
8