AGS Merlin GDP4 사용자 설명서 - 페이지 8
{카테고리_이름} AGS Merlin GDP4에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AGS Merlin GDP4 12 페이지. Gas safety products, gas detection panel
페이지 인쇄Merlin GDP4
5
Maintenance
To keep your panel in good working order, you must follow these steps:
DO carefully remove any accumulated dust from the outer enclosure once a month.
NEVER use detergents or solvents to clean your device – this may permenantly or temporarily
damage the panel
NEVER spray air fresheners, hair spray, paint or other aerosols near the device.
NEVER paint the device. Paint will seal vents and interfere with the device.
6
GDP4 Wiring Spec
1.
POWER: Mains Input 110-120VAC.
2.
GAS VALVE: Gas Solenoid Valve Power Output, 110-120VAC.
3.
GAS DETECTOR ZONE 1: 24VDC power supply (purchased separately).
4.
GAS DETECTOR ZONE 2: 24VDC power supply (purchased separately).
5.
GAS DETECTOR ZONE 3: 24VDC power supply (purchased separately).
6.
GAS DETECTOR ZONE 4: 24VDC power supply (purchased separately).
7.
EM REMOTE: Remote emergency stop buttons (purchased separately). VOLT FREE
INPUT
8.
HEAT SENSOR: Fusible Links (purchased separately). VOLT FREE INPUT
9.
FIRE PANEL (Supplied by others). VOLT FREE INPUT
10.
BMS OUT: output contacts. Normally Open, Common and Normally Closed.
11.
SOUNDER/STROBE: Alarm, 24VDC power supply (purchased separately).
12.
AUTO RESET & BMS SELECTION SWITCH
13.
ZONE ENABLE/DISABLE SWITCH
Rev: 06 05-19
User Guide
8