AFL FlexScan FS200 OTDR Manuel de référence rapide - Page 10
Parcourez en ligne ou téléchargez le pdf Manuel de référence rapide pour {nom_de_la_catégorie} AFL FlexScan FS200 OTDR. AFL FlexScan FS200 OTDR 13 pages. With smartauto, flexpress and linkmap
Imprimer la page
Source Settings and Features
1. Touch to enable/disable light source. RED dot indicates that source is ON.
1
2. Touch to select test mode: Wave ID, CW, Tone (270 Hz, 330 Hz, 1 kHz, 2 kHz).
2
– Select Wave ID mode for fastest loss measurements.
While in this mode, the FlexScan source transmits wavelength information, enabling a Wave ID power meter
to synchronize and measure power at received wavelength(s).
– Use CW mode to generate continuous wave light at a single wavelength.
– Generate Tone for fiber identification (270 Hz, 330 Hz, 1 kHz, 2 kHz).
3. Touch to select test wavelength: 1310, 1550 or 1650 nm (depending on model).
3
Power Meter Settings and Features
4. If used with non Wave ID source, touch to
4
select wavelength. If used with Wave ID source,
power meter automatically synchronizes to and
indicates received wavelength(s).
5. Hold to store new reference(s) at received
5
wavelength(s). Touch Ref/Set to view stored
reference(s).
6. Touch to toggle between power (in dBm or
6
Watts) and loss (dB) mode.
Note: Power meter detects and indicates fiber
identifying tones when used with a light source
capable of generating a modulated Tone signal.
Light Source and Power Meter Operation
6
5
4
1
10
2
3