AFL FlexScan FS200 OTDR Manual de referência rápida - Página 10
Procurar online ou descarregar pdf Manual de referência rápida para Equipamento de diagnóstico AFL FlexScan FS200 OTDR. AFL FlexScan FS200 OTDR 13 páginas. With smartauto, flexpress and linkmap
Imprimir página
Source Settings and Features
1. Touch to enable/disable light source. RED dot indicates that source is ON.
1
2. Touch to select test mode: Wave ID, CW, Tone (270 Hz, 330 Hz, 1 kHz, 2 kHz).
2
– Select Wave ID mode for fastest loss measurements.
While in this mode, the FlexScan source transmits wavelength information, enabling a Wave ID power meter
to synchronize and measure power at received wavelength(s).
– Use CW mode to generate continuous wave light at a single wavelength.
– Generate Tone for fiber identification (270 Hz, 330 Hz, 1 kHz, 2 kHz).
3. Touch to select test wavelength: 1310, 1550 or 1650 nm (depending on model).
3
Power Meter Settings and Features
4. If used with non Wave ID source, touch to
4
select wavelength. If used with Wave ID source,
power meter automatically synchronizes to and
indicates received wavelength(s).
5. Hold to store new reference(s) at received
5
wavelength(s). Touch Ref/Set to view stored
reference(s).
6. Touch to toggle between power (in dBm or
6
Watts) and loss (dB) mode.
Note: Power meter detects and indicates fiber
identifying tones when used with a light source
capable of generating a modulated Tone signal.
Light Source and Power Meter Operation
6
5
4
1
10
2
3