GAMA Electronics RF12V-2PR-ASL Manuel d'instruction - Page 2

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} GAMA Electronics RF12V-2PR-ASL. GAMA Electronics RF12V-2PR-ASL 4 pages.

Imprimer la page
GAMA Electronics RF12V-2PR-ASL Manuel d'instruction
RF12V-2PR-ASL
Instruction Manual
WWW.GAMAINC.COM
Programming Instructions
Each transmitter has its own unique internal address that is transmitted whenever a switch is pressed. The receiver needs to be
programmed to respond only to transmitters it is intended to operate with. The following steps configure the receiver to operate
with a particular transmitter(s). Up to thirty transmitters can be programmed to one receiver. Please read the entire programming
procedure before starting. Prior to programming the receiver, verify that the receiver is connected to the input power. When the
receiver enters program mode, all previous transmitter addresses that were programmed will be erased from the receiver's
memory.
1. Locate the pushbutton switch labeled "PROGRAM" on the receiver. Press and hold this switch until the red LED on the center of
the switch button illuminates (approximately 3 seconds). The receiver is now in the transmitter program mode, release the switch.
At this point, all the previously programmed transmitter addresses are erased from the receiver's memory.
2. Two Momentary Outputs: The transmitter up-arrow switch is used to select both outputs for momentary operation. Press and
release the up-arrow switch and the program LED will blink once to indicate both outputs are set for momentary operation.
3. Two Latching Outputs: The transmitter down-arrow switch is used to select both outputs for latching operation. Press and
release the down-arrow switch and the program LED will blink once to indicate both outputs have been set to latching operations.
4. M1 Output Momentary, M2 Output Latching: The transmitters left-arrow switch is used to select M1 output momentary and
M2 output latching. Press and release the left-arrow switch to configure the outputs, the program LED will blink once to indicate
M1 is momentary and M2 is latching.
5. M1 Output Latching, M2 Output Momentary: The transmitter right-arrow switch is used to select M1 output latching and M2
output momentary. Press and release the right-arrow switch to configure the outputs, the program LED will blink once to indicate
M1 is latching and M2 is momentary.
6. For additional transmitters to be programmed, follow steps 2 through 5. The last transmitter programmed will determine how the
outputs are configured.
7. The receiver will return to normal mode if no transmitter switches are pressed for 5-seconds. The red LED on the receiver will
flash and then turn off. The receiver is now in the normal mode of operation. This completes the programming instructions. The
receiver will retain the programming of the transmitter even when power is removed.
Page 2 REV A 06/30/20