GAMA Electronics RF12V-2PR-ASL Manual de instruções - Página 2

Procurar online ou descarregar pdf Manual de instruções para Recetor GAMA Electronics RF12V-2PR-ASL. GAMA Electronics RF12V-2PR-ASL 4 páginas.

RF12V-2PR-ASL

Instruction Manual

WWW.GAMAINC.COM

Programming Instructions

Each transmitter has its own unique internal address that is transmitted whenever a switch is pressed. The receiver needs to be

programmed to respond only to transmitters it is intended to operate with. The following steps configure the receiver to operate

with a particular transmitter(s). Up to thirty transmitters can be programmed to one receiver. Please read the entire programming

procedure before starting. Prior to programming the receiver, verify that the receiver is connected to the input power. When the

receiver enters program mode, all previous transmitter addresses that were programmed will be erased from the receiver's

memory.

1. Locate the pushbutton switch labeled "PROGRAM" on the receiver. Press and hold this switch until the red LED on the center of

the switch button illuminates (approximately 3 seconds). The receiver is now in the transmitter program mode, release the switch.

At this point, all the previously programmed transmitter addresses are erased from the receiver's memory.

2. Two Momentary Outputs: The transmitter up-arrow switch is used to select both outputs for momentary operation. Press and

release the up-arrow switch and the program LED will blink once to indicate both outputs are set for momentary operation.

3. Two Latching Outputs: The transmitter down-arrow switch is used to select both outputs for latching operation. Press and

release the down-arrow switch and the program LED will blink once to indicate both outputs have been set to latching operations.

4. M1 Output Momentary, M2 Output Latching: The transmitters left-arrow switch is used to select M1 output momentary and

M2 output latching. Press and release the left-arrow switch to configure the outputs, the program LED will blink once to indicate

M1 is momentary and M2 is latching.

5. M1 Output Latching, M2 Output Momentary: The transmitter right-arrow switch is used to select M1 output latching and M2

output momentary. Press and release the right-arrow switch to configure the outputs, the program LED will blink once to indicate

M1 is latching and M2 is momentary.

6. For additional transmitters to be programmed, follow steps 2 through 5. The last transmitter programmed will determine how the

outputs are configured.

7. The receiver will return to normal mode if no transmitter switches are pressed for 5-seconds. The red LED on the receiver will

flash and then turn off. The receiver is now in the normal mode of operation. This completes the programming instructions. The

receiver will retain the programming of the transmitter even when power is removed.

Page 2 REV A 06/30/20