GAME SolarPRO 4721 Manuel du propriétaire - Page 7
Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} GAME SolarPRO 4721. GAME SolarPRO 4721 12 pages. Curve heater
Également pour GAME SolarPRO 4721 : Manuel du propriétaire (13 pages)
Imprimer la page
4.
INSTALLATION INSTRUCTIONS
SolarPRO – Filter – Pool Layout
The system layouts below will help you install the SolarPRO to your above ground pool.
BEFORE INSTALLING SolarPRO
AFTER INSTALLING SolarPRO
NOTE: All instructions assume the pool and water filtration system are assembled.
1. SolarPRO Placement
Place the SolarPRO unit at least 10 feet away from the pool and in a location where it will receive the greatest amount of sunlight.
Extend the legs on the underside of the SolarPRO and angle in the direction of the sun's
natural path. See figure 1.
2. SolarPRO - Filter Pump Connection
a) Turn off filter pump.
b) Block water flow at both the pool return inlet and the filter pump outlet
to prevent water from flowing through the hoses.
c) Detach the pool return hose from your filter system and set aside.
d) Depending on the orientation of your pump setup and desired SolarPRO placement,
choose one side to be the inlet and the other to be the outlet. Disregard the "IN" and
"OUT" markings if present, either port can be used.
e) Locate filter hose and attach between pump (the port where the pool return hose
was previously connected) and the inlet using the included hose clamps .
NOTE: Depending on the size of your hose, the 32mm-38mm reducer may be
needed. Insert the reducer inside of the filter hose and attach using hose clamp.
Apply a small amount of silicon based lubricant to the outside of the reducer to
allow an easy fit.
IMPORTANT: Never move, drag, or relocate the SolarPRO unit when it is filled with
water. Doing so can cause the legs to break. Always empty the unit of all water
prior to moving or relocating.
SolarPRO
SolarPRO
SolarPRO
7
NOTE: Not shown to scale
Leg
Foot
Figure 1
SAVE THESE INSTRUCTIONS