GAME SolarPRO 4721 Посібник користувача - Сторінка 7

Переглянути онлайн або завантажити pdf Посібник користувача для Нагрівач для басейну GAME SolarPRO 4721. GAME SolarPRO 4721 12 сторінок. Curve heater
Також для GAME SolarPRO 4721: Посібник користувача (13 сторінок)

Друкувати сторінку

INSTALLATION INSTRUCTIONS

SolarPRO – Filter – Pool Layout

The system layouts below will help you install the SolarPRO to your above ground pool.

BEFORE INSTALLING SolarPRO

AFTER INSTALLING SolarPRO

NOTE: All instructions assume the pool and water filtration system are assembled.

1. SolarPRO Placement

Place the SolarPRO unit at least 10 feet away from the pool and in a location where it will receive the greatest amount of sunlight.

Extend the legs on the underside of the SolarPRO and angle in the direction of the sun's

natural path. See figure 1.

2. SolarPRO - Filter Pump Connection

a) Turn off filter pump.

b) Block water flow at both the pool return inlet and the filter pump outlet

to prevent water from flowing through the hoses.

c) Detach the pool return hose from your filter system and set aside.

d) Depending on the orientation of your pump setup and desired SolarPRO placement,

choose one side to be the inlet and the other to be the outlet. Disregard the "IN" and

"OUT" markings if present, either port can be used.

e) Locate filter hose and attach between pump (the port where the pool return hose

was previously connected) and the inlet using the included hose clamps .

NOTE: Depending on the size of your hose, the 32mm-38mm reducer may be

needed. Insert the reducer inside of the filter hose and attach using hose clamp.

Apply a small amount of silicon based lubricant to the outside of the reducer to

allow an easy fit.

IMPORTANT: Never move, drag, or relocate the SolarPRO unit when it is filled with

water. Doing so can cause the legs to break. Always empty the unit of all water

prior to moving or relocating.

SolarPRO

NOTE: Not shown to scale

Leg

Foot

Figure 1

SAVE THESE INSTRUCTIONS