GAME 4515 Manuel du propriétaire - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} GAME 4515. GAME 4515 8 pages. Pool filter system

Imprimer la page

3 way valve:

The filtering system is an economic basic model that is equipped with a 3-way valve on the filter tank's lid, so

that the cleaning can be controlled manually. Press the handle down with the palm of your and turn it to the

desired position. The following working positions are possible.

1. Filtering- Water from the pool is pressed through the filter tank and pumped back to the pool.

2. Backwash- Water from the pool is pressed through the filter tank and is pumped back to an

external outflow. Cleansing of collected impurities in the filter sand.

3. Closed- All valve outlets are closed and water cannot circulate.

NOTE: the 3-way handle on the filter tank valve must never be used in an attempt to lift the filter tank! The

handle is not constructed for this purpose and such an attempt may cause the handle to break.

Maintenance:

Interval

Weekly

Annual

NOTE: This filter system should not be used without a permanently installed skimmer in the pool.

Alternatively, a small leaf filter or floating surface-skimmer is used in the pool, assuming the pool is plastic with

solid sides. The skimmer captures leaves, twigs, and branches etc. that would otherwise collect in the pump

and totally block it. The pump is easily destroyed by such and the guarantee does not cover such damage.

Problems and Problem Solving:

Problem

The pressure gauge shows a

pressure exceeding 14 PSI.

Pressure is too low

Water escapes from the

backwash valve.

Leaking filter

The pump is not working

Sand in the pool.

Clean the per-filter basket. Carry out the backwash regardless of how dirty the

Get the filter system ready for winter before there are frosts. Replace the filter

sand in early spring before the sand filter is put into use again.

Cause

Dirty filter sand

Suction hose/skimmer basket

may be blocked

The gasket around the 3 way

valve is dirty and leaking. Grit in

the gasket.

Damaged gasket

The filter system has been

deactivated by the filter time or

a filter control.

The HFI device turns the pump

off.

The plug is not connected.

Damaged pump motor.

If the filter sand is new, there are

other pieces of grit that have

fastened in the filter.

The separator wall in the filter

tank is not correctly positioned.

The base plate is damaged.

Action

filter is.

Solution

Carry out a backwash

Clean suction hose/pool

skimmer.

The 3 way valve should be

removed from the filter lid, the

gasket should be cleaned.

Inspect the gasket and replace

with a new one if necessary.

Examine the settings

Turn on the HFI device again. If

it immediately turns itself off

again this means that the pump

or the HFI device is damaged.

Reconnect plug.

Replace the pump.

Carry out repeated backwash

until the backwash return water

is totally clear.

Correctly located the separator

wall in the filter tank.

Exchange the damaged plate for

a new one.