GAME 4515 Manual do Proprietário - Página 7
Procurar online ou descarregar pdf Manual do Proprietário para Filtro de piscina GAME 4515. GAME 4515 8 páginas. Pool filter system
Imprimir página3 way valve:
The filtering system is an economic basic model that is equipped with a 3-way valve on the filter tank's lid, so
that the cleaning can be controlled manually. Press the handle down with the palm of your and turn it to the
desired position. The following working positions are possible.
1. Filtering- Water from the pool is pressed through the filter tank and pumped back to the pool.
2. Backwash- Water from the pool is pressed through the filter tank and is pumped back to an
external outflow. Cleansing of collected impurities in the filter sand.
3. Closed- All valve outlets are closed and water cannot circulate.
NOTE: the 3-way handle on the filter tank valve must never be used in an attempt to lift the filter tank! The
handle is not constructed for this purpose and such an attempt may cause the handle to break.
Maintenance:
Interval
Weekly
Annual
NOTE: This filter system should not be used without a permanently installed skimmer in the pool.
Alternatively, a small leaf filter or floating surface-skimmer is used in the pool, assuming the pool is plastic with
solid sides. The skimmer captures leaves, twigs, and branches etc. that would otherwise collect in the pump
and totally block it. The pump is easily destroyed by such and the guarantee does not cover such damage.
Problems and Problem Solving:
Problem
The pressure gauge shows a
pressure exceeding 14 PSI.
Pressure is too low
Water escapes from the
backwash valve.
Leaking filter
The pump is not working
Sand in the pool.
Clean the per-filter basket. Carry out the backwash regardless of how dirty the
Get the filter system ready for winter before there are frosts. Replace the filter
sand in early spring before the sand filter is put into use again.
Cause
Dirty filter sand
Suction hose/skimmer basket
may be blocked
The gasket around the 3 way
valve is dirty and leaking. Grit in
the gasket.
Damaged gasket
The filter system has been
deactivated by the filter time or
a filter control.
The HFI device turns the pump
off.
The plug is not connected.
Damaged pump motor.
If the filter sand is new, there are
other pieces of grit that have
fastened in the filter.
The separator wall in the filter
tank is not correctly positioned.
The base plate is damaged.
Action
filter is.
Solution
Carry out a backwash
Clean suction hose/pool
skimmer.
The 3 way valve should be
removed from the filter lid, the
gasket should be cleaned.
Inspect the gasket and replace
with a new one if necessary.
Examine the settings
Turn on the HFI device again. If
it immediately turns itself off
again this means that the pump
or the HFI device is damaged.
Reconnect plug.
Replace the pump.
Carry out repeated backwash
until the backwash return water
is totally clear.
Correctly located the separator
wall in the filter tank.
Exchange the damaged plate for
a new one.
7