HIKOKI C 7SB3 Manuel d'instructions de manutention - Page 10

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions de manutention pour {nom_de_la_catégorie} HIKOKI C 7SB3. HIKOKI C 7SB3 16 pages.

Imprimer la page

SYMBOLS

WARNING

The following show symbols used for the machine.

Be sure that you understand their meaning before

use.

C7SB3 : Circular Saw

To reduce the risk of injury, user must read

instruction manual.

Always wear eye protection.

Always wear hearing protection.

Rated voltage

Cutting depth

Power Input

No-Load speed

Weight (without cord)

Switching ON

Switching OFF

Disconnect mains plug from electrical outlet

Blower

Prohibited action

Class II tool

STANDARD ACCESSORIES

In addition to the main unit (1 unit), the package

contains the accessories listed in the below.

○ Saw Blade (Dia. 185 mm) (mounted on tool) ................1

○ Hex. Bar wrench (mounted on tool)...............................1

○ Guide ............................................................................1

○ Wing-bolt ......................................................................1

○ Lock Spring ...................................................................1

○ Lever (short type) ..........................................................1

○ Dust collector ................................................................1

Standard accessories are subject to change without notice.

APPLICATIONS

Cutting various types of wood.

SPECIFICATIONS

The speciﬁ cations of this machine are listed in the Table on

page 12.

NOTE

Due to HiKOKI's continuing program of research and

development, the speciﬁ cations herein are subject to

change without prior notice.

MOUNTING AND OPERATION

Action

Adjusting the cutting depth

Adjusting the angle of inclination

(0o – 45o)

Adjusting the angle of inclination

(45o – 55o)

Regulating the guide

Cutting line

Using the cord holder

Mounting the dust collector set

Switch operation

Dismounting the saw blade

Cutting (Do not use the tool with

only the blower function.)

Mounting the Saw Blade

Adjusting the base and saw blade

to maintain perpendicularity

Selecting accessories

*1 Before beginning work, check to ensure that operating

the switch correctly turns the tool ON and OFF.

While the tool is plugged in to the receptacle, ensure that

the sawblade stops when the switch is turned OFF.

MAINTENANCE AND INSPECTION

1. Inspecting the saw blade

Since use of as dull saw blade will degrade eﬃ ciency

and cause possible motor malfunction, sharpen or

replace the saw blade as soon as abrasion is noted.

2. Inspecting the mounting screws

Regularly inspect all mounting screws and ensure that

they are properly tightened. Should any of the screws be

loose, retighten them immediately. Failure to do so could

result in serious hazard.

3. Inspecting the carbon brushes (Fig. 15)

The motor employs carbon brushes which are consumable

parts. Since an excessively worn carbon brush can result

in motor trouble, replace the carbon brushes with new

ones having the same carbon brush No. ⓐ shown in the

ﬁ gure when it becomes worn to or near the "wear limit" ⓑ.

In addition, always keep carbon brushes clean and ensue

that they slide freely within the brush holders.

CAUTION

When replacing the new carbon brushes, always use

genuine HiKOKI carbon brushes with the number

speciﬁ ed in the drawing.

4. Replacing carbon brushes (Fig. 15)

Disassemble the brush caps with a slotted-head

screwdriver. The carbon brushes can then be easily

removed.

Figure

Page

―