HIKOKI CB12-ST2 Instructions de remise - Page 6
Parcourez en ligne ou téléchargez le pdf Instructions de remise pour {nom_de_la_catégorie} HIKOKI CB12-ST2. HIKOKI CB12-ST2 16 pages. Band saw stand
Imprimer la page
English
7. Cutting thin or small diameter workpieces
When cutting a thin or small diameter workpiece, place
the vise guide supplied as a standard accessory onto the
top of vise (B) to reduce the clearance between the band
saw blade and the vise guide. (Fig. 13)
When cutting a thin or small diameter workpiece, if the
clearance between the band saw blade and vise (B) is
large, the workpiece may be deformed or vibrate in a
swinging manner.
Vise guide
Thin board to be cut
8. Angle cutting (Fig. 14)
When you adjust the angle of vise (B), you can cut
workpieces at an angle between a right-angle and 45
degrees.
(1) Loosen the two vise (B) adjustment bolts that are used
to secure vise (B) using the 8-mm hexagonal wrench
supplied as a standard accessory.
(2) By checking with the angle scale, rotate vise (B) to orient
its workpiece side at the desired angle.
(3) After adjusting the angle, fi rmly tighten the two vise (B)
adjustment bolts to secure vise (B).
(4) When the angle cutting work is fi nished, return vise (B) to
a right-angle position.
(See "Adjustment of the perpendicularity between vise
(B) and the band saw blade".)
NOTE
In order to improve the precision of angle cutting, apply
an angle gauge to the side of the band saw blade and the
workpiece side of vise (B) when securing vise (B).
Angle scale
Vise (B)
Fig. 13
Vise (B)
Vise (B)
adjustment bolt
Fig. 14
9. Contour cutting work
WARNING
Be sure to correctly install the protective cover, contour
table, and slide cover before use.
CAUTION
If the band saw blade is locked during the cutting
operation, immediately turn the switch off to stop the
operation.
<Installing the contour table (Fig. 15)>
(1) Lift the main unit to the upper limit position, then lower
it a little, and hold it in a position where the main unit is
perpendicular to the top surface of the base.
In this position, fi rmly tighten the stopper bolt of the hinge
to secure the main unit.
NOTE
If the stopper bolt is tightened although the main body
is not in a perpendicular orientation, the main unit may
wobble and cut the contour table.
(2) While placing the contour table on the guide plate, align
the groove with the band saw blade.
(3) Secure the contour table using vise (B).
Band saw blade
Contour table
Vise (A)
Top surface
of the base
<Installing the slide cover (Fig. 16)>
(1) Remove the M8 bolt. As this bolt is also used to fasten
the bearing holder, be careful not to drop the bearing
holder.
(2) Insert the protrusion on the slide cover into the slotted
hole in pulley guard (B), and tighten the M8 bolt to secure
it.
(3) Correctly install the slide cover using the 5-mm butterfl y
bolt. Before tightening the bolt, adjust the position of the
slide cover according to the height of the workpiece.
6
Groove
Vise (B)
Guide plate
Stopper bolt
Fig. 15