HIKOKI CB12-ST2 Teslim Talimatları - Sayfa 6

Testere HIKOKI CB12-ST2 için çevrimiçi göz atın veya pdf Teslim Talimatları indirin. HIKOKI CB12-ST2 16 sayfaları. Band saw stand

Sayfayı Yazdır

English

7. Cutting thin or small diameter workpieces

When cutting a thin or small diameter workpiece, place

the vise guide supplied as a standard accessory onto the

top of vise (B) to reduce the clearance between the band

saw blade and the vise guide. (Fig. 13)

When cutting a thin or small diameter workpiece, if the

clearance between the band saw blade and vise (B) is

large, the workpiece may be deformed or vibrate in a

swinging manner.

Vise guide

Thin board to be cut

8. Angle cutting (Fig. 14)

When you adjust the angle of vise (B), you can cut

workpieces at an angle between a right-angle and 45

degrees.

(1) Loosen the two vise (B) adjustment bolts that are used

to secure vise (B) using the 8-mm hexagonal wrench

supplied as a standard accessory.

(2) By checking with the angle scale, rotate vise (B) to orient

its workpiece side at the desired angle.

(3) After adjusting the angle, ﬁ rmly tighten the two vise (B)

adjustment bolts to secure vise (B).

(4) When the angle cutting work is ﬁ nished, return vise (B) to

a right-angle position.

(See "Adjustment of the perpendicularity between vise

(B) and the band saw blade".)

NOTE

In order to improve the precision of angle cutting, apply

an angle gauge to the side of the band saw blade and the

workpiece side of vise (B) when securing vise (B).

Angle scale

Vise (B)

Fig. 13

Vise (B)

adjustment bolt

Fig. 14

9. Contour cutting work

WARNING

Be sure to correctly install the protective cover, contour

table, and slide cover before use.

CAUTION

If the band saw blade is locked during the cutting

operation, immediately turn the switch oﬀ to stop the

operation.

(1) Lift the main unit to the upper limit position, then lower

it a little, and hold it in a position where the main unit is

perpendicular to the top surface of the base.

In this position, ﬁ rmly tighten the stopper bolt of the hinge

to secure the main unit.

NOTE

If the stopper bolt is tightened although the main body

is not in a perpendicular orientation, the main unit may

wobble and cut the contour table.

(2) While placing the contour table on the guide plate, align

the groove with the band saw blade.

(3) Secure the contour table using vise (B).

Band saw blade

Contour table

Vise (A)

Top surface

of the base

(1) Remove the M8 bolt. As this bolt is also used to fasten

the bearing holder, be careful not to drop the bearing

holder.

(2) Insert the protrusion on the slide cover into the slotted

hole in pulley guard (B), and tighten the M8 bolt to secure

it.

(3) Correctly install the slide cover using the 5-mm butterﬂ y

bolt. Before tightening the bolt, adjust the position of the

slide cover according to the height of the workpiece.

Groove

Vise (B)

Guide plate

Stopper bolt

Fig. 15