Adexa CP-12S Manuel de l'utilisateur - Page 10
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Adexa CP-12S. Adexa CP-12S 14 pages. Electric conveyor pizza oven
Imprimer la page
Keep it dry and dust-free. Do not expose it to direct sunlight. Avoid mechanical shocks and
vibrations. If it is for temporary storage, the weather-proof method should be taken.
6.2 Safety advice
Before starting repair or cleaning works, make sure the unit has been disconnected from
power socket (pull off the power plug!!!) and has cooled down completely. Do not use any
acid or abrasive detergents and make sure no water runs into the internal part of the unit.
To protect yourself from electric shock, never immerse the unit, the power cord and
the plug in water or other liquids.
CAUTION! The appliance is not jet-proofed. Therefore, you must not use any kind of
pressure water jet for cleaning it! Try to oil the driving and driven wheels to avoid noises
due to lack of oil and grease.
6.3 Cleaning
The device should be cleaned regularly. Pull the power plug before cleaning. Make sure it
does not touch any hot or wet areas. Damage will be done to the power cord. Let the unit
cool down completely.
CAUTION! Do not use any water to clean the switching unit (control panel). Thereby,
ensure no water egresses inside the unit. Thoroughly dry off the unit before operating the
unit again! Control panel, surface of the device and power cord should only be wiped off
with a piece of soft cloth dipping a mild cleaning detergent solution. You must not let water
enter the switching unit. This may lead to dangerous creepage current and malfunctions of
the appliance. Do not use any aggressive cleaning agents or abrasive materials as these could
damage the protecting film of the stainless steel and leave the iron particles on the surface of
the unit, which can cause rust. All parts must be dried thoroughly and reassemble the parts of
unit, which have been dismantled for cleaning. Store the device in a dry and ventilated place
if the unit stays idle for a long time. Keep it away from acid steams and caustic gases.
6.4 Safety instructions for maintenance
Check the power cord for damage periodically. Never operate the unit when the power cord
has been damaged or broken. If the power cord shows the above signs, call a qualified
electrician for replacement. It is highly recommended that the replaced power cord should be
the special type designated by the manufacturer. Damage may be done to the whole unit and
its internal wire if the wrong type of power cord has been used for replacement.
Only qualified electrician or personnel may perform the repair of the unit. All the necessary
replaced parts have to be the types designated by the manufacturer. Never attempt to repair
the unit on your own. Danger may occur if failed to do so.
7. Waste disposal
Discarding old devices at the end of its service life the discarded device has to be disposed in
accordance to the national regulations. It is advisable to contact a company which is