Adexa CP-12S Panduan Pengguna - Halaman 10

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Oven Adexa CP-12S. Adexa CP-12S 14 halaman. Electric conveyor pizza oven

Keep it dry and dust-free. Do not expose it to direct sunlight. Avoid mechanical shocks and

vibrations. If it is for temporary storage, the weather-proof method should be taken.

6.2 Safety advice

Before starting repair or cleaning works, make sure the unit has been disconnected from

power socket (pull off the power plug!!!) and has cooled down completely. Do not use any

acid or abrasive detergents and make sure no water runs into the internal part of the unit.

To protect yourself from electric shock, never immerse the unit, the power cord and

the plug in water or other liquids.

CAUTION! The appliance is not jet-proofed. Therefore, you must not use any kind of

pressure water jet for cleaning it! Try to oil the driving and driven wheels to avoid noises

due to lack of oil and grease.

6.3 Cleaning

The device should be cleaned regularly. Pull the power plug before cleaning. Make sure it

does not touch any hot or wet areas. Damage will be done to the power cord. Let the unit

cool down completely.

CAUTION! Do not use any water to clean the switching unit (control panel). Thereby,

ensure no water egresses inside the unit. Thoroughly dry off the unit before operating the

unit again! Control panel, surface of the device and power cord should only be wiped off

with a piece of soft cloth dipping a mild cleaning detergent solution. You must not let water

enter the switching unit. This may lead to dangerous creepage current and malfunctions of

the appliance. Do not use any aggressive cleaning agents or abrasive materials as these could

damage the protecting film of the stainless steel and leave the iron particles on the surface of

the unit, which can cause rust. All parts must be dried thoroughly and reassemble the parts of

unit, which have been dismantled for cleaning. Store the device in a dry and ventilated place

if the unit stays idle for a long time. Keep it away from acid steams and caustic gases.

6.4 Safety instructions for maintenance

Check the power cord for damage periodically. Never operate the unit when the power cord

has been damaged or broken. If the power cord shows the above signs, call a qualified

electrician for replacement. It is highly recommended that the replaced power cord should be

the special type designated by the manufacturer. Damage may be done to the whole unit and

its internal wire if the wrong type of power cord has been used for replacement.

Only qualified electrician or personnel may perform the repair of the unit. All the necessary

replaced parts have to be the types designated by the manufacturer. Never attempt to repair

the unit on your own. Danger may occur if failed to do so.

7. Waste disposal

Discarding old devices at the end of its service life the discarded device has to be disposed in

accordance to the national regulations. It is advisable to contact a company which is