Adexa AP238- PS15- 36 Manuel d'installation / Manuel d'utilisation et d'entretien - Page 12

Parcourez en ligne ou téléchargez le pdf Manuel d'installation / Manuel d'utilisation et d'entretien pour {nom_de_la_catégorie} Adexa AP238- PS15- 36. Adexa AP238- PS15- 36 20 pages. Under-mount hood

Imprimer la page
Adexa AP238- PS15- 36 Manuel d'installation / Manuel d'utilisation et d'entretien
INSTALLATION
Measure the distance between the cooking
surface and the bottom of the range hood. A
distance of 27" to 30" is recommended*.
*
Due to different ceiling height configurations, the
recommended height may not be applicable
Step 1: You have two options for installing this range hood (see INSTALLATION DIAGRAMS on page 7):
A. Determine the venting method and proceed if you would like tovent VERTICALLY.
1.
Using references in the Height & Clearance diagram, determine and clearly mark the
centerline on the bottom of the cabinet.
2.
Draw electrical wires through cabinet access opening on top of the range hood (refer to
figure 3), center the hood beneath the cabinet and flush with the front of the cabinet.
3.
From inside the hood, place hood mounting screws in the exact center of each knockout
holes and secure to the cabinet bottom. Tighten all screws until secure. Be careful when
using electrical screwdriver in order not to damage the range hood. Connect and secure
the 8'' round metal duct(refer to figure 4). Skip Part B below and proceed to Step 2.
Figure
B. Determine the venting method and proceed if you would like tovent HORIZONTALLY.
1.
Using references in the Height & Clearance diagram, determine and clearly mark a
centerline on the wall. Place two mounting screws on the wall, leaving a gap of 1/8'' from
the wall. To secure the hood onto the studs in the wall is highlyrecommended.
2.
Secure the mounting bracket to the back of the hood with the six screws, as shown in figure 5.
3.
Puncture the knockout wire access hole and rear duct access hole on the back of the hood,
draw electrical wires through the wire access hole (refer to figure 6) and attach
rectangular vent adapter.
4.
Align the mounting bracket to the screws on the wall and hang the hood in place as
illustrated in figure 7.
.
CAUTION: Make certain the range hood is secure before releasing!
3
6
5
Figure
Figure
12
4
Figure
7
Figure