- ページ 12

換気フード Adexa AP238- PS15- 36のPDF インストレーション・マニュアル / 使用・お手入れマニュアルをオンラインで閲覧またはダウンロードできます。Adexa AP238- PS15- 36 20 ページ。 Under-mount hood

INSTALLATION

Measure the distance between the cooking

surface and the bottom of the range hood. A

distance of 27" to 30" is recommended*.

Due to different ceiling height configurations, the

recommended height may not be applicable

Step 1: You have two options for installing this range hood (see INSTALLATION DIAGRAMS on page 7):

A. Determine the venting method and proceed if you would like tovent VERTICALLY.

Using references in the Height & Clearance diagram, determine and clearly mark the

centerline on the bottom of the cabinet.

Draw electrical wires through cabinet access opening on top of the range hood (refer to

figure 3), center the hood beneath the cabinet and flush with the front of the cabinet.

From inside the hood, place hood mounting screws in the exact center of each knockout

holes and secure to the cabinet bottom. Tighten all screws until secure. Be careful when

using electrical screwdriver in order not to damage the range hood. Connect and secure

the 8'' round metal duct(refer to figure 4). Skip Part B below and proceed to Step 2.

Figure

B. Determine the venting method and proceed if you would like tovent HORIZONTALLY.

Using references in the Height & Clearance diagram, determine and clearly mark a

centerline on the wall. Place two mounting screws on the wall, leaving a gap of 1/8'' from

the wall. To secure the hood onto the studs in the wall is highlyrecommended.

Secure the mounting bracket to the back of the hood with the six screws, as shown in figure 5.

Puncture the knockout wire access hole and rear duct access hole on the back of the hood,

draw electrical wires through the wire access hole (refer to figure 6) and attach

rectangular vent adapter.

Align the mounting bracket to the screws on the wall and hang the hood in place as

illustrated in figure 7.

CAUTION: Make certain the range hood is secure before releasing!

Figure