Gamma X-ST Manuel du propriétaire - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Gamma X-ST. Gamma X-ST 19 pages.
Également pour Gamma X-ST : Manuel du propriétaire (19 pages), Manuel du propriétaire (19 pages)

Imprimer la page

ASSEMBLY INSTRUCTIONS

Support Post Installation (cont'd)

Place the support post onto the central slot

of the turntable. With your fingers placed

through the large hole in the underside of the

turntable, press the mounting plate against

the inside top surface of the turntable while

aligning the hole in the support post with the

hole in the mounting plate and fix them with

the mounting bolt. Repeat procedure on to

attach the support post on the opposite side

of the turntable.

String Clamp Installation

The post of the string clamp and tube of the

string clamp base are treated with grease to

provide protection against corrosion during

shipping. Remove any excessive grease

with a clean cloth prior to use. The post and

tube may also be cleaned with isopropyl

alcohol. After this type of thorough cleaning,

the post and tube should be treated with a

light coating of machine oil to protect the

surfaces against corrosion and to ensure

smooth operation.

Installing the Tensioner

Remove the button head screw and washer

located at the end of the tensioner bar with

the 3 mm hex wrench provided. Slide the

tensioner onto the bar, being careful to align

the bar with all of the bearings and the drive

gear with the gear track. Replace the screw

and washer into the end of the tensioner bar.

Note: The tensioner bar is equipped with a

tensioner travel stop to limit travel of the

tensioner along the bar.