Gamma X-ST Owner's Manual - Page 5

Browse online or download pdf Owner's Manual for Stringing Machines Gamma X-ST. Gamma X-ST 19 pages.
Also for Gamma X-ST: Owner's Manual (19 pages), Owner's Manual (19 pages)

Gamma X-ST Owner's Manual
ASSEMBLY INSTRUCTIONS
Support Post Installation (cont'd)
Place the support post onto the central slot
of the turntable. With your fingers placed
through the large hole in the underside of the
turntable, press the mounting plate against
the inside top surface of the turntable while
aligning the hole in the support post with the
hole in the mounting plate and fix them with
the mounting bolt. Repeat procedure on to
attach the support post on the opposite side
of the turntable.
String Clamp Installation
The post of the string clamp and tube of the
string clamp base are treated with grease to
provide protection against corrosion during
shipping. Remove any excessive grease
with a clean cloth prior to use. The post and
tube may also be cleaned with isopropyl
alcohol. After this type of thorough cleaning,
the post and tube should be treated with a
light coating of machine oil to protect the
surfaces against corrosion and to ensure
smooth operation.
Installing the Tensioner
Remove the button head screw and washer
located at the end of the tensioner bar with
the 3 mm hex wrench provided. Slide the
tensioner onto the bar, being careful to align
the bar with all of the bearings and the drive
gear with the gear track. Replace the screw
and washer into the end of the tensioner bar.
Note: The tensioner bar is equipped with a
tensioner travel stop to limit travel of the
tensioner along the bar.
4