Green Air Designs Su-27 Flanker Manuel d'instruction - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Green Air Designs Su-27 Flanker. Green Air Designs Su-27 Flanker 17 pages.

Imprimer la page

Step 2 – Main Fuse Fitment

Refer to drawings on page "step 2" for basic build.

Our next task is to make up the main fuse section.

1. Tape up main fuse with packing tape on the outside only (stops the

Depron from cracking when rolling and forming).

2. Groove the inside of the fuse to allow them to roll. (Refer to drawings If

Not Laser cut).

3. Hand form the fuse to nicely curved shape and tape into position.

4. Roll the nose section of the fuse into a circle, epoxy both top and

bottom joints and tape together at correct angle, allow to set.

5. You can use fairly warm water (NOT BOILING) to set the shape into

fuse. Alternatively, just tape the shape and leave over night. You will

cause hysterisis in the foam and take the shape over time.

6. Glue top of fuse together and sand as necessary to make nice fit.

7. Once set, trial fit the fuse to the base. Sand any inaccuracies so fuse

fits snugly, pin, tape and then glue into place, allow to set completely

before removing pins, tape etc.

Great now you the basis of your Su-27 Flanker!!!!!