Green Audio HDS 4X1 Manuel de l'utilisateur - Page 10
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Green Audio HDS 4X1. Green Audio HDS 4X1 18 pages. 4x1 hdmi switcher with arc
Imprimer la page
Operation
Manual Switching
• Set the unit to manual switching mode by pressing the front panel Auto Source button for three
seconds. The Mode LED will illuminate green.
• Manually select the desired HDMI source by pressing the front panel Auto Source button.
Automatic Switching
• Set the unit to automatic switching mode by pressing the front panel Auto Source button for three
seconds. The Mode LED will illuminate yellow.
The switcher follows the below logic when automatically switching:
• Upon detecting a new input/source connection, the switcher will automatically switch to the new
source.
• If an active source is lost or powered down, the switcher will automatically switch to the first sensed
input starting at input 1 and cycling up (1 > 2 > 3 > 4).
• Upon switcher power reboot, the switcher will automatically switch to the last source. If that
input/source connection isn't present, the switcher will automatically switch to the first sensed input
starting at input 1 and cycling up (1 > 2 > 3 > 4).
1.
IR Remote Control
• Connect an IR receiver to the 3.5mm IR port on the switcher.
• The included IR remote control features three sections: the top section
controls the switcher, and the bottom two sections control the connected
source and display devices provided they support compatible CEC commands.
RS232 Control
• Connect a 3.5mm to DB9 RS232 cable to the 3.5mm RS232 port on the
switcher.
• Verify the control system is configured to the proper RS232 parameters:
o Baud Rate: 9600
o Data bit: 8
o Stop bit: 1
o Parity bit: none
© 2021 Green Audio Manufacturing. All Rights Reserved
GreenAudioMfg.com