Green Audio HDS 4X1 Kullanıcı Kılavuzu - Sayfa 10

Anahtar Green Audio HDS 4X1 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Green Audio HDS 4X1 18 sayfaları. 4x1 hdmi switcher with arc

Operation

• Set the unit to manual switching mode by pressing the front panel Auto Source button for three

seconds. The Mode LED will illuminate green.

• Manually select the desired HDMI source by pressing the front panel Auto Source button.

• Set the unit to automatic switching mode by pressing the front panel Auto Source button for three

seconds. The Mode LED will illuminate yellow.

The switcher follows the below logic when automatically switching:

• Upon detecting a new input/source connection, the switcher will automatically switch to the new

source.

• If an active source is lost or powered down, the switcher will automatically switch to the first sensed

input starting at input 1 and cycling up (1 > 2 > 3 > 4).

• Upon switcher power reboot, the switcher will automatically switch to the last source. If that

input/source connection isn't present, the switcher will automatically switch to the first sensed input

starting at input 1 and cycling up (1 > 2 > 3 > 4).

IR Remote Control

• Connect an IR receiver to the 3.5mm IR port on the switcher.

• The included IR remote control features three sections: the top section

controls the switcher, and the bottom two sections control the connected

source and display devices provided they support compatible CEC commands.

RS232 Control

• Connect a 3.5mm to DB9 RS232 cable to the 3.5mm RS232 port on the

switcher.

• Verify the control system is configured to the proper RS232 parameters:

o Baud Rate: 9600

o Data bit: 8

o Stop bit: 1

o Parity bit: none

GreenAudioMfg.com