ADF LINEA NMV Manuel d'installation - Page 2

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} ADF LINEA NMV. ADF LINEA NMV 18 pages. Variable speed controller

Imprimer la page

IMPORTANT:

• Must be installed in accordance with AS/NZS 3000.

• Must be installed to the manufacturers' specifications.

• Power supply must be installed by a licensed electrician.

• If the power cables are damaged, for any reason, do not use. Have the cord replaced

immediately.

• A means for switching off and isolating the appliance, for maintenance requirements, is

recommended.

• In all heat zones the wiring should be thermally insulated with the silicone sleeves

provided.

The cable for the control switch and thermostat switch is made with a high

temperature rated silicon outer case.

your electrician, standard electrical cables can be used outside of the heat zones. The

240 Volt supply cord and plug is not supplied; confirm length of supply cord required with

electrician.

Mount the control switch into wall, do not mount in wall above the heater or within

200mm from each side of the heater.

See installation instructions on page 5.

If additional cabling is required check with