ADF LINEA NMV 설치 매뉴얼 - 페이지 2

{카테고리_이름} ADF LINEA NMV에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ADF LINEA NMV 18 페이지. Variable speed controller

IMPORTANT:

• Must be installed in accordance with AS/NZS 3000.

• Must be installed to the manufacturers' specifications.

• Power supply must be installed by a licensed electrician.

• If the power cables are damaged, for any reason, do not use. Have the cord replaced

immediately.

• A means for switching off and isolating the appliance, for maintenance requirements, is

recommended.

• In all heat zones the wiring should be thermally insulated with the silicone sleeves

provided.

The cable for the control switch and thermostat switch is made with a high

temperature rated silicon outer case.

your electrician, standard electrical cables can be used outside of the heat zones. The

240 Volt supply cord and plug is not supplied; confirm length of supply cord required with

electrician.

Mount the control switch into wall, do not mount in wall above the heater or within

200mm from each side of the heater.

See installation instructions on page 5.

If additional cabling is required check with