KitchenAid Architect Series II KFGS306VSS Manuel d'instructions d'installation - Page 2

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions d'installation pour {nom_de_la_catégorie} KitchenAid Architect Series II KFGS306VSS. KitchenAid Architect Series II KFGS306VSS 20 pages. 30" (76.2 cm) and 36" (91.4 cm) gas built-in cooktop
Également pour KitchenAid Architect Series II KFGS306VSS : Dimensions (1 pages), Manuel des dimensions (1 pages)

Imprimer la page
WARNING: If the information in this manual is not followed exactly, a fire or explosion
may result causing property damage, personal injury or death.
– Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this
or any other appliance.
– WHAT TO DO IF YOU SMELL GAS:
•
Do not try to light any appliance.
•
Do not touch any electrical switch.
•
Do not use any phone in your building.
•
Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's
instructions.
•
If you cannot reach your gas supplier, call the fire department.
– Installation and service must be performed by a qualified installer, service agency or
the gas supplier.
WARNING: Gas leaks cannot always be detected by smell.
Gas suppliers recommend that you use a gas detector approved by UL or CSA.
For more information, contact your gas supplier.
If a gas leak is detected, follow the "What to do if you smell gas" instructions.
In the State of Massachusetts, the following installation instructions apply:
Installations and repairs must be performed by a qualified or licensed contractor, plumber, or gasfitter qualified or licensed by
the State of Massachusetts.
If using a ball valve, it shall be a T-handle type.
A flexible gas connector, when used, must not exceed 3 feet.
Gather the required tools and parts before starting installation.
Tools needed
Tape measure
Flat-blade screwdriver
" (#0 [2 mm]) flat blade
screwdriver (screwdriver
shaft must be a minimum of
2" [5.1 cm] long)
" combination wrench
Pipe wrench
2

INSTALLATION REQUIREMENTS

Tools and Parts

Wrench or pliers
Needle-nose pliers
Marker or pencil
Pipe-joint compound
resistant to LP gas
Noncorrosive leak-detection
solution
Parts supplied
Gas pressure regulator
Burner grates
Burner caps
Clamping brackets (2)
2 " (6.4 cm) clamping screws (2)
Parts needed
Check local codes and consult gas supplier. Check existing gas
supply and electrical supply. See "Electrical Requirements" and
"Gas Supply Requirements" sections.