- ページ 2

クックトップ KitchenAid Architect Series II KFGS306VSSのPDF 取付説明書をオンラインで閲覧またはダウンロードできます。KitchenAid Architect Series II KFGS306VSS 20 ページ。 30" (76.2 cm) and 36" (91.4 cm) gas built-in cooktop
KitchenAid Architect Series II KFGS306VSS にも：寸法 (1 ページ), 寸法マニュアル (1 ページ)

ページを印刷する

WARNING: If the information in this manual is not followed exactly, a fire or explosion

may result causing property damage, personal injury or death.

– Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this

or any other appliance.

– WHAT TO DO IF YOU SMELL GAS:

•

Do not try to light any appliance.

•

Do not touch any electrical switch.

•

Do not use any phone in your building.

•

Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's

instructions.

•

If you cannot reach your gas supplier, call the fire department.

– Installation and service must be performed by a qualified installer, service agency or

the gas supplier.

WARNING: Gas leaks cannot always be detected by smell.

Gas suppliers recommend that you use a gas detector approved by UL or CSA.

For more information, contact your gas supplier.

If a gas leak is detected, follow the "What to do if you smell gas" instructions.

In the State of Massachusetts, the following installation instructions apply:

Installations and repairs must be performed by a qualified or licensed contractor, plumber, or gasfitter qualified or licensed by

the State of Massachusetts.

If using a ball valve, it shall be a T-handle type.

A flexible gas connector, when used, must not exceed 3 feet.

Gather the required tools and parts before starting installation.

Tools needed

Tape measure

Flat-blade screwdriver

" (#0 [2 mm]) flat blade

screwdriver (screwdriver

shaft must be a minimum of

2" [5.1 cm] long)

" combination wrench

Pipe wrench

INSTALLATION REQUIREMENTS

Tools and Parts

Wrench or pliers

Needle-nose pliers

Marker or pencil

Pipe-joint compound

resistant to LP gas

Noncorrosive leak-detection

solution

Parts supplied

Gas pressure regulator

Burner grates

Burner caps

Clamping brackets (2)

2 " (6.4 cm) clamping screws (2)

Parts needed

Check local codes and consult gas supplier. Check existing gas

supply and electrical supply. See "Electrical Requirements" and

"Gas Supply Requirements" sections.