Green Gorilla ProLine PowerPack X Manuel du propriétaire - Page 3

Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Green Gorilla ProLine PowerPack X. Green Gorilla ProLine PowerPack X 4 pages.

Imprimer la page

1. Insert the Green Gorilla standard wall charger into a 110 Vac wall outlet.

2. Locate the charging port cover on your PowerPack X. The charging port cover is

located on the right side of the PowerPack as shown in Figure 4.

3. The charging port is protected by a ip open cover. Gently pull up on the tab to

expose the charging port.

4. Firmly insert the wall charger plug into the port.

5. The wall charger indicator light will turn green when the lithium ion cells are fully

charged. Charge time is approximately 3-5 hrs.

6. After fully charging, remove the charger plug from the PowerPack charging port

and push the protective cover back into place.

7. Ensure that the PowerPack X battery level indicator shows green when the unit is

turned on.

IMPORTANT! If the PowerPack fails to turn on after charging, pull back the

protective cover and gently reinsert. A built-in safety interlock system that

prevents usage while charging may have become engaged due to over- insertion

of the protective cover.

PowerPack Usage

Turn PowerPack on by depressing the on/o power button on the top surface of the

PowerPack as shown above ( gure 7).

If fully charged, a green light will display on both the top surface and the center of the

knob. Both the knob indicator light and the power level indicator are synchronized to

indicate power depletion during normal operation. Green = Full Charged, Yellow = Half

Charge, Red = Low Battery ( gures 8 & 9).

During normal operation, the PowerPack will automatically cycle to maintain the

factory pressure set point as necessary. The Power Level Indicator Lights will remain on

to indicate the PowerPack is in pressure sensing mode.

g. 7