CeoTronics CT-DECT Base Manuel d'utilisation - Page 10

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} CeoTronics CT-DECT Base. CeoTronics CT-DECT Base 14 pages. Headset for wireless duplex communication
Également pour CeoTronics CT-DECT Base : Manuel d'utilisation (20 pages), Manuel d'utilisation (20 pages), Manuel d'utilisation (14 pages), Manuel d'utilisation (20 pages)

Imprimer la page

Connection release

Press one of the three push-buttons in the middle of the push-button bank on the base unit. The base

unit is disconnected from the standard unit. A high beep tone then sounds in the communication set of

the base unit and of the standard unit.

(3)

Three-party conference

Below the designations standard unit 1 and standard unit 2 are used only for the purpose of better

differentiation in the operating instructions. Both standard units operate with equal entitlement.

Connection setup

Press one of the three push-buttons in the middle of the push-button bank on the base unit. The base

unit sets up automatically a connection with the active standard units 1 and 2. Upon setup of the

connection a high beep tone sounds in the communication set of the calling base unit and of the called

standard units 1 and 2, and the base unit switches over automatically to three-party conference mode.

Subsequently duplex communication (speech and simultaneous listening) is possible for the three

parties. In the case of communication sets with PTT button, press the PTT button and keep it pressed

while speaking (see section 2.10).

Connection release

Press one of the three push-buttons in the middle of the push-button bank on the base unit. The base

unit disconnects itself from the standard units 1 and 2. A high beep tone then sounds in the

communication sets of the three units.

4.3.3 Connection setup and release by the standard unit

(1)

Prerequisites

Units subscribed (see sections 3...3.2.2)

Units switched on and synchronized (section 4.2)

(2)

Two-party conference

Connection setup

Press one of the three push-buttons in the middle of the push-button bank on the standard unit. When

the connection is set up a high beep tone sounds in the communication set of the calling standard unit

and of the called base unit. Subsequently duplex communication (speech and simultaneous listening) is

possible for both parties. In the case of communication sets with PTT button, press the PTT button and

keep it pressed while speaking (see section 2.10).

Connection release

Press one of the three push-buttons in the middle of the push-button bank on the standard unit. The

standard unit is disconnected from the base unit. A high beep tone then sounds in the communication

set of the standard unit and of the base unit.

(3)

Three-party conference

Below the designations standard unit 1 and standard unit 2 are used only for the purpose of better

differentiation in the operating instructions. Both the standard units operate with equal entitlement.

Connection setup

Press one of the three push-buttons in the middle of the push-button bank on the standard unit 1.

Standard unit 1 sets up a connection with the active base unit. Upon setup of the connection a high

beep tone sounds in the communication set of the standard unit 1 and of the called base unit.

The base unit does not automatically set up a connection with standard unit 2. Not until one of the three

push-buttons in the middle of the push-button bank on the standard unit 2 has been pressed, does

standard unit 2 set up a connection with the base unit. If a connection exists between standard unit 1

and the base unit, the base unit then switches over automatically to three-party conference mode.