HIKVISION TurboHD H0T Series Manuel de l'utilisateur - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} HIKVISION TurboHD H0T Series. HIKVISION TurboHD H0T Series 17 pages. Turbo hd bullet & dome camera
Également pour HIKVISION TurboHD H0T Series : Manuel de l'utilisateur (17 pages), Manuel de l'utilisateur (16 pages), Manuel de l'utilisateur (17 pages), Manuel de l'utilisateur (13 pages), Manuel de l'utilisateur (18 pages), Manuel de l'utilisateur (15 pages), Manuel de l'utilisateur (15 pages)

6. Power on the camera to check whether the image

on the monitor is gotten from the optimum angle. If

not, adjust the camera according to the figure below

to get an optimum angle.

1). Loosen the P screw to adjust the pan position [0°

to 360°]. Tighten the screw after completing the

adjustment.

2). Loosen the T screw to adjust the tilt position [0°

to 180°]. Tighten the screw after completing the

adjustment.

3). Loosen the R screw to rotate the camera [0° to

360°]. Tighten the screw after completing the

adjustment.

2.2 Ceiling/Wall Mounting of Type II Camera

Steps:

1. Paste the drill template (supplied) to the place

where you want to install the camera.

2. Drill the screw holes according to the drill template,

and the cable hole (optional) on the ceiling.

Note:

Drill the cable hole in the center of the drill template,

when adopting ceiling outlet to route the cable.

3. Route the cables through the cable hole (optional)

or the side opening.

4. Fix the camera to the ceiling with supplied screws.

Figure 2-5 Fix the Camera to the Ceiling

Note:

The supplied screw package contains self-tapping



screws, and expansion bolts.

For cement wall/ceiling, expansion bolts are



required to fix the camera. For wooden

wall/ceiling, self-tapping screws are required.

Figure 2-3 3-axis Adjustment

Figure 2-4 Drill Template

Screw

Hole