DecoRad Floormate Manuel rapide de l'opérateur

Parcourez en ligne ou téléchargez le pdf Manuel rapide de l'opérateur pour {nom_de_la_catégorie} DecoRad Floormate. DecoRad Floormate 2 pages.

DecoRad® Floormate – Operator Quick Guide
*always wear Safety package ( Facial shield- Tyvec suit – gloves)
1. Safety
* bystanders should keep distance (unprotected minimal 10 meter)
2. Transport *Fold down handlebar and secure, the Floor Mate can be lifted (2 pax.)
*pull back the pin to unfold the handlebar
*make sure that the lamp is in transport mode (red handles are in upright pos.)
*when moving to the job site, please use the very rear (transport) wheels by pulling
the Floormate backwards – (prevent dirt from attaching or damaging the wheels)
3. Prep.
*adjust the lamphouse by moving the red handles completely down (= 6 mm distance)
*the lamp height is adjustable when there is unevenness in the floor
*place the heatshield under the lamphouse (this will prevent from burn marks)
*use the accompanied cable and attach it at the back of the Floormate
*Now Floormate can be plugged into mains (190/250, vac – 16Ah – 50 or 60Hz)
*Press power on button
4. Set-up
from Display *when the power cable is plugged in
*the display will show for 2 seconds the software version that is used
*set speed by: pushing plus (+) and minus (-) at the
showed is meter / per minute (min.: 3.5 m/pm & max.: 20 m/pm) – the speed can be
adjusted by pushing the plus (+) or minus (-) - CONFIRM speed by pressing enter
*start UV Lamp; push ON and a green LED (activated) will show activated, this will be
followed by a red LED (wait) that tells the operator to wait (warming up:apx. 40
seconds) UV lamp will go from 0 to 100% and will dim automatically when UV is ready
*the orange LED (standby) will burn when the Floormate is ready to use (the green
LED (activated) will be on as well) – Lamp will be in dimming mode (20%)
*the Floormate is now ready to use
5. Operating *remove the Floormate from the heatshield
*keep the Floormate with burning UV lamp moving at all times
*press 1 x left button (LAMP) in the handlebar to activate UV lamp full power
immediately followed by pressing 1 x right button (DRIVE) in handlebar
NOW YOU ARE CURING ON FULL POWER WITH FLOORMATE DRIVING ON SET SPEED
*DRIVE function motorized speed is NOT possible when the UV lamp is in 20% mode
*Floormate can also be operated with UV lamp full power without DRIVE function
motorized speed– this will allow the operator to cure edges and corners by pushing
*push OFF to switch off the UV lamp – allow 3 minutes cool down on heatshield
before: start up again / unplug power cord
6. Safety
*when UV lamp in 100% full power mode with Floormate not moving for four seconds,
the UV lamp will automatically dim to 20% and the machine starts beeping (U.92)
please move the Floormate to prevent from burn marks and press enter on display
(non-movement indication with automatic system shut-down U.93)
*tilt angle detection of 25˚: if the machine is tilted too far backwards, the UV lamp will
shut off automatically preventing accidental exposure off UV radiation ( U.91 )
*in case of emergency use the emergency stop !
time – the number
same