DecoRad Floormate Operator's Quick Manual

Browse online or download pdf Operator's Quick Manual for Cutter DecoRad Floormate. DecoRad Floormate 2 pages.

Print Page

DecoRad® Floormate – Operator Quick Guide

*always wear Safety package ( Facial shield- Tyvec suit – gloves)

1. Safety

* bystanders should keep distance (unprotected minimal 10 meter)

2. Transport *Fold down handlebar and secure, the Floor Mate can be lifted (2 pax.)

*pull back the pin to unfold the handlebar

*make sure that the lamp is in transport mode (red handles are in upright pos.)

*when moving to the job site, please use the very rear (transport) wheels by pulling

the Floormate backwards – (prevent dirt from attaching or damaging the wheels)

3. Prep.

*adjust the lamphouse by moving the red handles completely down (= 6 mm distance)

*the lamp height is adjustable when there is unevenness in the floor

*place the heatshield under the lamphouse (this will prevent from burn marks)

*use the accompanied cable and attach it at the back of the Floormate

*Now Floormate can be plugged into mains (190/250, vac – 16Ah – 50 or 60Hz)

*Press power on button

4. Set-up

from Display *when the power cable is plugged in

*the display will show for 2 seconds the software version that is used

*set speed by: pushing plus (+) and minus (-) at the

showed is meter / per minute (min.: 3.5 m/pm & max.: 20 m/pm) – the speed can be

adjusted by pushing the plus (+) or minus (-) - CONFIRM speed by pressing enter

*start UV Lamp; push ON and a green LED (activated) will show activated, this will be

followed by a red LED (wait) that tells the operator to wait (warming up:apx. 40

seconds) UV lamp will go from 0 to 100% and will dim automatically when UV is ready

*the orange LED (standby) will burn when the Floormate is ready to use (the green

LED (activated) will be on as well) – Lamp will be in dimming mode (20%)

*the Floormate is now ready to use

5. Operating *remove the Floormate from the heatshield

*keep the Floormate with burning UV lamp moving at all times

*press 1 x left button (LAMP) in the handlebar to activate UV lamp full power

immediately followed by pressing 1 x right button (DRIVE) in handlebar

NOW YOU ARE CURING ON FULL POWER WITH FLOORMATE DRIVING ON SET SPEED

*DRIVE function motorized speed is NOT possible when the UV lamp is in 20% mode

*Floormate can also be operated with UV lamp full power without DRIVE function

motorized speed– this will allow the operator to cure edges and corners by pushing

*push OFF to switch off the UV lamp – allow 3 minutes cool down on heatshield

before: start up again / unplug power cord

6. Safety

*when UV lamp in 100% full power mode with Floormate not moving for four seconds,

the UV lamp will automatically dim to 20% and the machine starts beeping (U.92)

please move the Floormate to prevent from burn marks and press enter on display

(non-movement indication with automatic system shut-down U.93)

*tilt angle detection of 25˚: if the machine is tilted too far backwards, the UV lamp will

shut off automatically preventing accidental exposure off UV radiation ( U.91 )

*in case of emergency use the emergency stop !

time – the number

same