IKEA IUD9500VX0 Manuel d'instructions d'installation - Page 7
Parcourez en ligne ou téléchargez le pdf Manuel d'instructions d'installation pour {nom_de_la_catégorie} IKEA IUD9500VX0. IKEA IUD9500VX0 40 pages. Undercounter dishwasher plastic giant tubmodels
Également pour IKEA IUD9500VX0 : Instructions pour l'utilisateur (20 pages)
Imprimer la page
Option 3: Waste Disposer
- no air gap
1. Remove the disposer knockout plug. Do not cut end of drain
hose.
2.
Attach drain hose to disposer inlet with large spring-type
clamp.
This connection must be before the drain trap and at least 20"
(50.8 cm) above the floor where dishwasher will be installed.
It is recommended
that the drain hose be looped up and
securely fastened to the underside of the counter.
3.
J
A. Large spring-type clamp
C. Disposer inlet
B.Drain hose
D. Drain
trap
Insert drain hose through hole cut in cabinet to the front center
of opening where drain connection will be made.
...............
A
A. Drain hose
Option
4" No Waste Disposer
- no air gap
1. Cut end of drain hose if needed (do not cut ribbed section).
2.
[
A. Drain hose (cut here if needed)
Attach drain hose to waste tee with 11/2"to 2" (3.8 to 5 cm)
screw-type clamp**.
This connection must be before the drain trap and at least 20"
(50.8 cm) above the floor where dishwasher will be installed.
It is recommended
that the drain hose be looped up and
securely fastened to the underside of the counter.
3.
A. Waste tee
D. Drain hose
B. Drain trap
E. Drain hose (cut
C. Screw-type
clamp
here if needed)
Insert drain hose through hole cut in cabinet to the front center
of opening where drain connection will be made.
A
A. Drain hose
**Parts available from local plumbing supply stores.
Electrical
Connection
Option 1: Direct Wire Method
Helpful Tip: Wiring the dishwasher will be easier if you route wire
into the cabinet opening from the right-hand side.
1. Drill a 3/4"(1.9 cm) hole in right-hand cabinet side, rear or floor.
Preferred and optional locations are shown.
A
B
2.
A. Optional locations
B. Preferred locations
Wood cabinet: Sand hole until smooth.
Metal cabinet: Cover hole with grommet, not provided.