IKEA RENLIG DW60 Manuel de l'utilisateur - Page 19
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} IKEA RENLIG DW60. IKEA RENLIG DW60 28 pages. Renlig
Également pour IKEA RENLIG DW60 : Manuel de l'utilisateur (24 pages), Manuel de l'utilisateur (24 pages), Manuel de configuration (16 pages)
Imprimer la page
ENGLISH
Water supply pressure
Capacity (place settings)
Energy class
Washing class
Drying class
Noise (dB(A))
Average annual energy con-
2)
sumption (kWh)
Average annual water con-
2)
sumption (litres)
1) If the pressure in your area is lower or higher, please contact your After Sales Service.
2) The data is based on the washing programme for test institutes assuming 220 cycles per a year.
Information on the electrical connection, voltage and overall power is given on the rat-
ing plate on the inner edge of the dishwasher door.
Installation
Caution! Refer to the assembly
instructions, in order to proceed with the
installation.
Warning! Make sure that mains plug is
disconnected from the mains socket
during installation.
Place the appliance on the floor and install it
under a counter (kitchen worktop or sink).
Water connection
This appliance has a special inlet hose
for water stop later defined as aqualock.
Water inlet hose
Connected the appliance to a hot (max. 60°)
or cold water supply.
If the hot water comes from alternative sour-
ces of energy that are more environmentally
friendly (e.g. solar or photovoltaic panels and
aeolian), use a hot water supply to decrease
energy consumption.
Height (cm)
Depth (cm)
Minimum
1)
Maximum
12
A
A
A
49
231
3520
0,5 bar (0,05 MPa)
8 bar (0,8 MPa)
If a repair is necessary, the appliance must
be easily accessible for the engineer.
Put the appliance adjacent to a water tap
and a drain.
For the venting of the dishwasher only water
fill, water drain and power supply cable open-
ings are necessary.
Connect the inlet hose to a water tap with an
external thread of 3/4".
Caution! Do not use connection hoses
from an old appliance.
Caution! If you connect the appliance
to new pipes or pipes that are not used
for a long time, we recommend to run the
water for some minutes before you connect
the inlet hose.
19
81,8-87,8
55,5