IKEA RENLIG DW60 Panduan Pengguna - Halaman 19

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Mesin pencuci piring IKEA RENLIG DW60. IKEA RENLIG DW60 28 halaman. Renlig
Juga untuk IKEA RENLIG DW60: Panduan Pengguna (24 halaman), Panduan Pengguna (24 halaman), Setup Manual (16 halaman)

Halaman Cetak

ENGLISH

Water supply pressure

Capacity (place settings)

Energy class

Washing class

Drying class

Noise (dB(A))

Average annual energy con-

sumption (kWh)

Average annual water con-

sumption (litres)

1) If the pressure in your area is lower or higher, please contact your After Sales Service.

2) The data is based on the washing programme for test institutes assuming 220 cycles per a year.

Information on the electrical connection, voltage and overall power is given on the rat-

ing plate on the inner edge of the dishwasher door.

Installation

Caution! Refer to the assembly

instructions, in order to proceed with the

installation.

Warning! Make sure that mains plug is

disconnected from the mains socket

during installation.

Place the appliance on the floor and install it

under a counter (kitchen worktop or sink).

Water connection

This appliance has a special inlet hose

for water stop later defined as aqualock.

Water inlet hose

Connected the appliance to a hot (max. 60°)

or cold water supply.

If the hot water comes from alternative sour-

ces of energy that are more environmentally

friendly (e.g. solar or photovoltaic panels and

aeolian), use a hot water supply to decrease

energy consumption.

Height (cm)

Depth (cm)

Minimum

Maximum

231

3520

0,5 bar (0,05 MPa)

8 bar (0,8 MPa)

If a repair is necessary, the appliance must

be easily accessible for the engineer.

Put the appliance adjacent to a water tap

and a drain.

For the venting of the dishwasher only water

fill, water drain and power supply cable open-

ings are necessary.

Connect the inlet hose to a water tap with an

external thread of 3/4".

Caution! Do not use connection hoses

from an old appliance.

Caution! If you connect the appliance

to new pipes or pipes that are not used

for a long time, we recommend to run the

water for some minutes before you connect

the inlet hose.

81,8-87,8

55,5