GAPOSA QC101 Manuel d'utilisation - Page 12
Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} GAPOSA QC101. GAPOSA QC101 16 pages. Single-phase control unit
Imprimer la page
PROGRAMMING OF
WORKING TIME
The work time is the time it takes to perform a complete opening or
closing operation. By performing this procedure the board automatically
learns the stroke. Without programming, the working time lasts 30 sec.
ATTENTION: During the programming procedure ensure that
no obstacle activates the safety devices (photocells or safety
edges) and stops the movement of the door. If that happens, it
is necessary to proceed with a new programming cycle of the
working time (close the current programming, perform the RESET
and proceed with a new cycle).
In order to program the working time, you must:
1. Test the motor phases and check that the limit switches are calibrated
and connected properly! If during the procedure the safety systems
intervene, the movement of the motor stops.
2. Place the door halfway.
3. Put DIP 5 and 6 in OFF.
4. Put DIP 6 in ON. The red LED will switch on.
5. Give a START/STOP signal (terminal 7), the door starts to open. When
opening is complete send a new START/STOP signal.
6. Give a START/STOP signal (terminal 7), the door starts to close. When
closing is complete send a new START/STOP signal.
7. Set DIP 6 in OFF. The red LED will switch off indicating the end of the
programming procedure.
NOTE: In order to ensure the complete closing and opening under
all conditions, the control unit automatically adds 4 seconds to
the programmed time.