GAPOSA QC101 사용 설명서 - 페이지 12

{카테고리_이름} GAPOSA QC101에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. GAPOSA QC101 16 페이지. Single-phase control unit

PROGRAMMING OF

WORKING TIME

The work time is the time it takes to perform a complete opening or

closing operation. By performing this procedure the board automatically

learns the stroke. Without programming, the working time lasts 30 sec.

ATTENTION: During the programming procedure ensure that

no obstacle activates the safety devices (photocells or safety

edges) and stops the movement of the door. If that happens, it

is necessary to proceed with a new programming cycle of the

working time (close the current programming, perform the RESET

and proceed with a new cycle).

In order to program the working time, you must:

1. Test the motor phases and check that the limit switches are calibrated

and connected properly! If during the procedure the safety systems

intervene, the movement of the motor stops.

2. Place the door halfway.

3. Put DIP 5 and 6 in OFF.

4. Put DIP 6 in ON. The red LED will switch on.

5. Give a START/STOP signal (terminal 7), the door starts to open. When

opening is complete send a new START/STOP signal.

6. Give a START/STOP signal (terminal 7), the door starts to close. When

closing is complete send a new START/STOP signal.

7. Set DIP 6 in OFF. The red LED will switch off indicating the end of the

programming procedure.

NOTE: In order to ensure the complete closing and opening under

all conditions, the control unit automatically adds 4 seconds to

the programmed time.