GAPOSA QCXSUN Manuel - Page 3

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} GAPOSA QCXSUN. GAPOSA QCXSUN 4 pages.

Imprimer la page
2. PROGRAMMING QCXSUN
IMPORTANT: QCXSUN sensor can only be programmed once the radio motor has already been
programmed to a transmitter.
1
2
3. SUN SENSIBILITY THRESHOLD ADJUSTMENT
1. Press and hold BUTTON 3 (the LED will turn on at first) until the LED starts to flash slowly,
release BUTTON 3
2. Adjust the threshold by using BUTTONS 1 and 3 which will allow you to either increase
(Button 1) or decrease (Button 3) the threshold.
Whenever a button is pressed the LED flashes according to the level of sun threshold (1,
2 or 3).
Threshold 1 - 5 Klux (default) = Low light (most sensitive)
Threshold 2 - 30 Klux
Threshold 3 - 60 Klux
3. Once the desired threshold has been obtained press BUTTON 2 to confirm.
1
Led
flashes
slowly
NOTE: It is important to program the sun sensor's threshold within 30 seconds or the time
out function will automatically exit the programming procedure without saving the new
threshold.
3
= Med Light
= High light (less sensitive)
2
Press 1
to increase
the threshold
1 Press and hold PROG-TX button of the MASTER
transmitter till the motor starts moving
2 Check the motor rotation then release Prog-TX
button
3 Press 1+2 (if motor move UP) or 2+3 (if motor move
DOWN) button of the QCXSUN
Transmitter is now programmed
> led flashes 1 time
> led flashes 2 time
> led flashes 3 time
Press 3
to decrease
the threshold
QCXSUN
3
Press 2
to confirm
threshold