GAPOSA QCXSUN Manual - Halaman 3

Jelajahi secara online atau unduh pdf Manual untuk Kontrol Jarak Jauh GAPOSA QCXSUN. GAPOSA QCXSUN 4 halaman.

2. PROGRAMMING QCXSUN

IMPORTANT: QCXSUN sensor can only be programmed once the radio motor has already been

programmed to a transmitter.

3. SUN SENSIBILITY THRESHOLD ADJUSTMENT

1. Press and hold BUTTON 3 (the LED will turn on at first) until the LED starts to flash slowly,

release BUTTON 3

2. Adjust the threshold by using BUTTONS 1 and 3 which will allow you to either increase

(Button 1) or decrease (Button 3) the threshold.

Whenever a button is pressed the LED flashes according to the level of sun threshold (1,

2 or 3).

Threshold 1 - 5 Klux (default) = Low light (most sensitive)

Threshold 2 - 30 Klux

Threshold 3 - 60 Klux

3. Once the desired threshold has been obtained press BUTTON 2 to confirm.

Led

flashes

slowly

NOTE: It is important to program the sun sensor's threshold within 30 seconds or the time

out function will automatically exit the programming procedure without saving the new

threshold.

= Med Light

= High light (less sensitive)

Press 1

to increase

the threshold

1 Press and hold PROG-TX button of the MASTER

transmitter till the motor starts moving

2 Check the motor rotation then release Prog-TX

button

3 Press 1+2 (if motor move UP) or 2+3 (if motor move

DOWN) button of the QCXSUN

Transmitter is now programmed

> led flashes 1 time

> led flashes 2 time

> led flashes 3 time

Press 3

to decrease

the threshold

QCXSUN

Press 2

to confirm

threshold