Makita 3620 Manuel d'instruction - Page 5
Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Makita 3620. Makita 3620 13 pages. Router
Également pour Makita 3620 : Manuel d'instruction (20 pages), Manuel d'instruction (17 pages), Manuel d'instruction (17 pages), Manuel d'instruction (18 pages)
Imprimer la page
FUNCTIONAL
DESCRIPTION
1
2
1. Stopper pole
2. Screw
1
1. Lock lever
1
2
3
4
5
1. Depth pointer
2. Screw
3. Stopper pole
4. Adjusting hex bolt
5. Stopper block
CAUTION:
•
Always be sure that the tool is switched off and unplugged before
adjusting or checking function on the tool.
Adjusting the depth of cut
003252
Place the tool on a flat surface. Loosen the screw securing the stopper pole.
Loosen the lock lever and lower the tool body until the bit just touches the flat
surface. Tighten the lock lever to lock the tool body.
003253
Next, lower the stopper pole until it makes contact with the adjusting hex bolt.
003254
Align the depth pointer with the "0" graduation.
Raise the stopper pole until the desired depth of cut is obtained. The depth of
cut is indicated on the scale (1 mm per graduation) by the depth pointer. Then
tighten the screw to secure the stopper pole.
Now, your predetermined depth of cut can be obtained by loosening the lock
lever and then lowering the tool body until the stopper pole makes contact with
the adjusting hex bolt.
CAUTION:
•
Since excessive cutting may cause overload of the motor or difficulty in
controlling the tool, the depth of cut should not be more than 15 mm at a
pass when cutting grooves with an 8 mm diameter bit.
•
When cutting grooves with a 20 mm diameter bit, the depth of cut should
not be more than 5 mm at a pass.
When you wish to cut grooves more than 15 mm deep with an 8 mm
diameter bit or more than 5 mm deep with a 20 mm diameter bit, make
several passes with progressively deeper bit settings.
5