Makita 3620 Manuale di istruzioni - Pagina 5

Sfoglia online o scarica il pdf Manuale di istruzioni per Utensile elettrico Makita 3620. Makita 3620 13. Router
Anche per Makita 3620: Manuale di istruzioni (20 pagine), Manuale di istruzioni (17 pagine), Manuale di istruzioni (17 pagine), Manuale di istruzioni (18 pagine)

FUNCTIONAL

DESCRIPTION

1. Stopper pole

2. Screw

1. Lock lever

1. Depth pointer

2. Screw

3. Stopper pole

4. Adjusting hex bolt

5. Stopper block

CAUTION:

•

Always be sure that the tool is switched off and unplugged before

adjusting or checking function on the tool.

Adjusting the depth of cut

003252

Place the tool on a flat surface. Loosen the screw securing the stopper pole.

Loosen the lock lever and lower the tool body until the bit just touches the flat

surface. Tighten the lock lever to lock the tool body.

003253

Next, lower the stopper pole until it makes contact with the adjusting hex bolt.

003254

Align the depth pointer with the "0" graduation.

Raise the stopper pole until the desired depth of cut is obtained. The depth of

cut is indicated on the scale (1 mm per graduation) by the depth pointer. Then

tighten the screw to secure the stopper pole.

Now, your predetermined depth of cut can be obtained by loosening the lock

lever and then lowering the tool body until the stopper pole makes contact with

the adjusting hex bolt.

CAUTION:

•

Since excessive cutting may cause overload of the motor or difficulty in

controlling the tool, the depth of cut should not be more than 15 mm at a

pass when cutting grooves with an 8 mm diameter bit.

•

When cutting grooves with a 20 mm diameter bit, the depth of cut should

not be more than 5 mm at a pass.

When you wish to cut grooves more than 15 mm deep with an 8 mm

diameter bit or more than 5 mm deep with a 20 mm diameter bit, make

several passes with progressively deeper bit settings.