Makita AN611 Manuel d'instruction - Page 7
Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Makita AN611. Makita AN611 13 pages. Construction coil nailer
Également pour Makita AN611 : Manuel d'instruction (19 pages), Ventilation des pièces (4 pages), Ventilation des pièces (4 pages), Manuel d'instruction (12 pages)
Imprimer la page
1
005244
OPERATION
CAUTION:
Make sure all safety systems are in working order
•
before operation.
1.
To drive a nail, you may place the contact element
against the workpiece and pull the trigger, or
2.
Pull the trigger first and then place the contact
element against the workpiece.
No. 1 method is for intermittent nailing, when you
•
wish to drive a nail carefully and very accurately.
No. 2 method is for continuous nailing.
005245
005246
CAUTION:
However when the tool is set to the "Intermittent
•
Nailing" mode, WITH THE TRIGGER HELD IN A
HALF-PULLED POSITION, an unexpected nailing
could occur, if contact element is allowed to
re-contact against the workpiece or the other
surface under the influence of recoil.
In order to avoid this unexpected nailing, perform
as follows;
1. Air fitting
2. Air socket
2
A.
Do not place the contact element against the
workpiece with excessive force.
B. Pull the trigger fully and hold it on for 1-2 seconds
after nailing.
For No. 1 method, set the change lever to the
•
"Intermittent Nailing" position. For No. 2 method,
set the change lever to the "Continuous Nailing"
position. After using the change lever to change the
nailing method, always make sure that the change
lever is properly set to the position for the desired
nailing method.
1
2
005247
CAUTION:
Operating the tool without nails shortens the life of
•
the tool and should be avoided.
Anti exhaust
Air exhaust direction can be changed easily by
•
rotaiting the exhaust cover. Change it when
necessary.
Jammed nailer
CAUTION:
Always lock the trigger, disconnect the hose and
•
remove the nails from the magazine before
cleaning a jam.
When the nailer becomes jammed, do as follows:
Open the door and magazine cap and remove the nail
coil. Insert a small rod or the like into the ejection port and
tap it with a hammer to drive out the nail jamming from
the ejection port. Reset the nail coil and close the
magazine cap and door.
005614
7
1. Intermittent
nailing
2. Continuous
nailing
3. Change lever
3
4. Trigger lock
4
1. Small rod
1
2. Ejection port
2