Jandy ePump Manuel d'installation - Page 14

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Jandy ePump. Jandy ePump 16 pages. Variable speed pump user interface

Imprimer la page

Page 14

5.3

General Labels

Using the arrow keys, select a general label from the list to

assign to the Preset. Press MENU to assign the label to the

Preset.

LABEL PRESET

5.4

Custom Labels

In the custom label mode, the controller displays a flashing

cursor at the character position to be changed. Using the

arrow keys, change the character as desired. Press MENU to

accept the change and advance to the next character position.

Press any preset key "

" through "4" to return to the

previous cursor position.

LABEL PRESET

1:PRESET 1

Continue this procedure until the end of the label is reached.

The new label is saved when MENU is pressed at the last

character position.

5.5

Display Light Control

The controller's display is equipped with a backlight to aid

viewing in low light conditions.

From the setup menu, select DISPLAY LIGHT. Press

MENU. Using the arrow keys, select the desired operating

mode for the display backlight:

LIGHT OFF: Turn off display backlight.

LIGHT ON: Turn on display backlight.

FILTRATION

ePUMP

2 MIN TIMEOUT: Turn on display backlight, with automatic

turn-off after two (2) minutes since the last key press.

SELECT USER SETUP

DISPLAY LIGHT

5.6

Language Selection

From the setup menu, select LANGUAGE using the arrow

keys. Press MENU. Using the arrow keys, select the desired

language. Press MENU to save the selection.

SELECT USER SETUP

5.7

Run Duration (Presets 3 and 4 Only)

Presets "3" and "4" may be programmed to run for a specified

duration after being manually started. This run duration

is programmable from 30 minutes to eight (8) hours, in

increments of 30 minutes. A setting of 0:00 disables the run

duration feature, allowing the preset to run indefinitely.

From the setup menu, select RUN DURATION. Press

MENU. Using the arrow keys, select the preset to be

programmed. Press MENU. Set the desired run duration for

the preset using the arrow keys. Press MENU to accept.

SELECT USER SETUP

RUN DURATION

ePUMP

LANGUAGE

ePUMP