Jandy ePump Panduan Instalasi - Halaman 14
Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Pompa Air Jandy ePump. Jandy ePump 16 halaman. Variable speed pump user interface
![Jandy ePump Panduan Instalasi](/uploads/products/server2/2125176/2125176.png)
Page 14
5.3
General Labels
Using the arrow keys, select a general label from the list to
assign to the Preset. Press MENU to assign the label to the
Preset.
LABEL PRESET
2
MENU
5.4
Custom Labels
In the custom label mode, the controller displays a flashing
cursor at the character position to be changed. Using the
arrow keys, change the character as desired. Press MENU to
accept the change and advance to the next character position.
Press any preset key "
" through "4" to return to the
previous cursor position.
LABEL PRESET
1:PRESET 1
2
MENU
Continue this procedure until the end of the label is reached.
The new label is saved when MENU is pressed at the last
character position.
5.5
Display Light Control
The controller's display is equipped with a backlight to aid
viewing in low light conditions.
From the setup menu, select DISPLAY LIGHT. Press
MENU. Using the arrow keys, select the desired operating
mode for the display backlight:
LIGHT OFF: Turn off display backlight.
LIGHT ON: Turn on display backlight.
FILTRATION
3
4
ePUMP
3
4
ePUMP
2 MIN TIMEOUT: Turn on display backlight, with automatic
turn-off after two (2) minutes since the last key press.
SELECT USER SETUP
DISPLAY LIGHT
2
MENU
5.6
Language Selection
From the setup menu, select LANGUAGE using the arrow
keys. Press MENU. Using the arrow keys, select the desired
language. Press MENU to save the selection.
SELECT USER SETUP
2
MENU
5.7
Run Duration (Presets 3 and 4 Only)
Presets "3" and "4" may be programmed to run for a specified
duration after being manually started. This run duration
is programmable from 30 minutes to eight (8) hours, in
increments of 30 minutes. A setting of 0:00 disables the run
duration feature, allowing the preset to run indefinitely.
From the setup menu, select RUN DURATION. Press
MENU. Using the arrow keys, select the preset to be
programmed. Press MENU. Set the desired run duration for
the preset using the arrow keys. Press MENU to accept.
SELECT USER SETUP
RUN DURATION
2
MENU
3
4
ePUMP
LANGUAGE
4
ePUMP
3
3
4
ePUMP