AEG 30" DEO76 Manuel de l'utilisateur - Page 19
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} AEG 30" DEO76. AEG 30" DEO76 33 pages. 30” built-in double oven
Également pour AEG 30" DEO76 : Manuel de l'utilisateur (13 pages)
Imprimer la page
- 1. Table of Contents
- 2. A - Installation Check and Warnings
- 3. B - Accessories
- 4. C - Using the Appliance for the First Time
- 5. D - Electronic Programmer Operation
- 6. E - Cooking Modes and Instructions
- 7. F - Cleaning and Maintenance
- 8. G - Trouble Shooting Guide
- 9. H - Installation Instructions
- 10. I - Electrical Wiring Diagrams and Instructions
- 11. Warranty
To re-fit the oven door:
i.
Holding the door at an angle to the oven, slide the hinges into the oven frame, making sure
that on each side the top curved arm fits into the top slot and the lower arm fits into the
bottom slot.
ii.
Make sure the hinges are pushed as far as they will go and the lower arm engages into the
plate mounted in the oven frame.
iii.
Open the door fully and ensure the pin fully disengages from the hole. The door can now be
opened and as normal.
How to Rotate Doors in the Double and Single Oven
NOTE: Side Opening Only
This should only be done by a qualified person or installer. We recommend that it be a two person task
to ensure support of the heavy door apparatus during changeover. Damage done to the appliance
during a door rotation may effect the warranty provision for the appliance.
Stage1:
REMOVE THE BOTTOM DOOR FOR DOUBLE OVEN OR THE MAIN DOOR FOR
SINGLE OVEN
a) Remove the screws fixing the hinge to the oven front frame, being careful to support the
door, then remove the door and place in a safe place
b) Remove the door catch by removing the two screws top and bottom of the door latch on
the opposite side of the oven front frame to the hinges
c) Remove the screws fitted in the thread holes in the oven front frame to allow the re-
positioning of the door hinge to the opposite side
Stage 2: (FOR DOUBLE OVENS ONLY) REMOVE THE TOP DOOR AS PER STAGE 1 ABOVE AND
LEAVE IN POSITION THE FITTED MIDDLE SPACER
4.
Remove the screws fixing the bracket of the middle spacer profile
5.
Remove the screws fixing the hinge of the top door
6.
Remove the door with the middle profile fixed to the hinge, rotate 180° place in a safe place
ready for re-affixing
Stage 3: FITTING THE DOORS – FOR DOUBLE OVENS AND SINGLE OVENS
19